Product Manual
Page 7 of 23
Accessories that may be suitable for one product may create a risk of injury when used with another
tool. Never use an accessory that has a lower operating speed or operating pressure than the tool
itself.
Keep guards in place and in working order. Never operate the product without the guards in place.
Do not leave the tool running unattended.
Specific Operation Warnings
⚠WARNING
To prevent serious injury or property damage, read and understand owner's manual before
operating.
Wear ANSI Z87.1 compliant goggles and other protective gear while operating.
Wear an adiabatic glove when operating pump.
Do not exceed the maximum working air pressure of 115 PSI.
Never point the dispenser at people or animals.
Do not use the pump near open flames. Do not smoke during this operation.
When not in use, disconnect the air supply air to the pump.
Inspect before each use; check that all connections are tight and secure.
Never use if parts are damaged or broken; replace damaged or broken parts before operating.
Use only original parts when repairing the pump.
Always disconnect the air supply after use so that oil can't leak out in case one of the pump's
components should break.
The compressed air must be filtered to avoid dust and moisture into pump.
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer's
warnings.
Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.
Disconnect air hose and relieve air pressure before servicing.
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces.
Do not lift or move pressurized equipment.
Always dispose of oil and other liquids according to local waste authority guidelines.
Not for use by or around children.