Product Manual

Page 16 of 23
Handling and storage of the pump do not require any special procedures. The dust in compressed air
can slow down or even block the motor cylinder. The following steps may prevent this from happening:
1) Add 50 grams of appropriate lubricating oil to the air inlet hole weekly; operate the pump for
several minutes after adding oil.
2) Turn on the pump for several minutes until the moving parts are fully lubricated. Repeat if
necessary. Do this on a weekly basis.
For the pumps that are attached with compressed air treatment equipment, empty the water retained in
the reservoir of the filter-purger frequently.
For the pumps that are attached with a lubricator, pay close attention to the lubricator's grease level
and refill with NLGL-2 conditions when necessary.
Keep the pump in a dry and cool place out of the reach of children.
Cleaning the Pump:
Operate the pump and drain off the oil, then the pump could be applied to other kind of oil.
Troubleshooting
Problem
Possible Cause
Solution
The pump
continues to
operate after the
gun trigger has
been released.
The pump continues to operate after
the gun trigger has been released.
1.Remove cover and take out
pump and follower plate.
Compact grease and fill the
drum or replace it for a full one.
2.Check and tighten
connections. Repair the leak.
3.Disassemble and clean
valves. Replace any that are
damaged.
Reduction of the
grease delivery or
reduced pressure
in the grease
delivery.
1. Air pockets in the grease drum.
2. Silencer (210) is dirtied.
3.There is blockage at some point in
the grease circuit.
4.Ball valve (103) closes incorrectly
due to dirt or wearing.
5. Damaged O-ring (216).
1.Remove the cover and take
out the pump and the follower
plate. Compact the grease and
fill the drum
2.Clean or recharge the
silencer.
3.Use clean grease.
4.Replace any damaged parts.
Air loss through
the air exhaust.
1.The sliding valve (7) does not close
properly.
2.The press piece (36) is broken.
3.Damaged O-ring (208, 209, or 211).
4.Damaged piston (2).
5.Damaged washer (31).
6.Broken spring (33).
1.Disassemble and clean.
Replace any damaged parts.