Product Manual

Page 13 of 23
warnings.
 Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.
 Disconnect air hose and relieve air pressure before servicing.
 Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces.
Operating Instructions
⚠WARNING
 Wear ANSI Z87.1 compliant goggles and other protective gear while operating.
 Wear an adiabatic glove when operating pump.
 Do not exceed the maximum working air pressure of 115 PSI.
 Never point the dispenser at people or animals.
 Do not use the pump near open flames. Do not smoke during this operation.
 When not in use, disconnect the air supply air to the pump.
 The compressed air must be filtered to avoid dust and moisture into pump.
 Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer's
warnings.
 Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents, or
fluids containing such solvents in pressurized aluminum equipment. Such use could result in a
chemical reaction, with the possibility of explosion.
 Do not lift or move pressurized equipment.
⚠WARNING
SKIN INJECTION HAZARD
 Fluid from the dispensing valve, leaks, or ruptured components can inject fluid into your body and
cause extremely serious injury, including the need for amputation or blood poisoning. Fluid splashed
in the eyes or on the skin can also cause serious injury. If a fluid injection injury occurs, GET
IMMEDIATE SURGICALTREATMENT. Do not treat as a simple cut.
 Do not point the dispensing valve at anyone or at any part of the body.
 Do not put your hand or fingers over the end of the dispensing valve.
 Do not stop or deflect leaks with your hand, body, glove, or rag.
 Use only extensions and no-drip tips which are designed for use with your dispensing valve.
 Do not use a low pressure flexible nozzle with this equipment.
 Follow the Pressure Relief Procedure if the dispensing valve clogs before you clean, check or