Product Manual
10 of 16
Operating Instructions
⚠WARNING
Know and follow applicable national, state, and local safety codes pertaining to installing and
operating electrical equipment for use with flammable liquids.
Know and follow all safety precautions when handling petroleum fuels.
Ensure that all equipment operators have access to adequate instructions concerning safe
operating and maintenance procedures.
To ensure safe operation, all fuel transfer systems must be properly grounded. Proper grounding
means a continuous metal-to-metal contact from one component to the next, including tank, bung,
pump, meter, filter, hose, and nozzle. Care should be taken to ensure proper grounding during
initial installation and after any service or repair procedures.
To prevent physical injury, observe precautions against fire or explosion when dispensing fuel. Do
not operate the system in the presence of any source of ignition including running or hot engines,
lighted cigarettes, or gas or electric heaters.
Observe precautions against electrical shock when operating the system. Serious or fatal shock
can result from operating electrical equipment in damp or wet locations.
Inspect external pump wiring regularly to make sure it is correctly attached to the battery. To avoid
electrical shock, use extra care when connecting the pump to power.
Avoid prolonged skin contact with petroleum fuels. Use protective goggles, gloves and aprons in
case of splashing or spills. Change saturated clothing and wash skin promptly with soap and
water.
Wear the proper protective gear including ANSI Z87.1 compliant safety goggles while operating.
This product should not be used for fluid transfer into an aircraft. This product is not suited for use
with fluids for human consumption or fluids containing water.
Extreme operating conditions with working cycles longer than 30 minutes can cause the motor
temperature to rise, thus damaging the motor itself. Each 30-minute working cycle should always
be followed by a 30-minute power-off cooling phase.
Use PTFE tape on all pipe threads.
Do not exceed the maximum by-passing time of 3 minutes.
Do not run dry past 30 seconds.
Burn hazard. To reduce the risk of burns, do not touch hot surfaces.
Operating Conditions
Temperature: Min. -68°F Max.104°F (Min.-20°C Max. +40°C)
Relative Humidity: max 90%
Fluid Compatibility
These products are compatible with the following fluids:
Gasoline, Diesel, Kerosene, and Mineral Spirits
⚠CAUTION
Do NOT use with other fluids without consulting manufacturer.