22 GPM FUEL PUMP WITH TURBINE DIGITAL METER OWNER’S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Roughneck™ Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This machine is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and do not use this equipment for a purpose for which it was not intended. 5. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace damaged or worn parts immediately. 6. Do not overreach.
to mount the bracket (away from sources of heat, flame, or sparks). Attach the bracket using bolts (not provided) in the four holes provided. NOTE: For best results the unit should be placed as flush with the level of liquid to be pumped as possible, and the height from the pump to the lowest fuel level should be less than 6.5ft. (2m). 2. Screw the suction hose on the inlet fitting of pump, and the delivery hose on the outlet fitting of pump. 3.
2 Reset the resettable total. 3 Start dispensing into a measuring glass. Stop dispensing when over 5 liters of volume is reached, then read out the actual value. The volume that is displayed on the LCD is the Display Value, not the Actual Value, which may be slightly higher. For example, in the figure on the right, the Display Value is 18.96 while the Actual Value is 20.75. 4 Press the MENU key. Keep it pressed until showed as the right fig.
MECHANICAL RISKS Mechanical parts subject to wear and tear Parts such as blades, bearings, rotors, etc. should be replaced with original spare parts by qualified personal only or in authorized service centers. Risks due to extreme temperatures Make sure the pump works at the ambient temperature ranging from -4°F (-20°C) to 113°F (45°C). Remember that operating at a very low temperature (about -4°F/ -20°C) can freeze the oil inside the pump. This situation can cause serious damage to the motor pump unit.
DIAGRAM & PARTS LIST Part No. Description Quantity 1 Nut 4 2 Housing 1 3 Elbow 1 4 Outlet 1 5 Washer 4 6 Screw 4 7 Pump 1 8 Inlet with filter 1 9 Manual Nozzle 1 10 Turbine Digital meter 1 For replacement parts and technical questions, please call 1-800-222-5381. WARRANTY One-year limited warranty Distributed by Northern Tool + Equipment Co., Inc. Burnsville, MN 55306 NorthernTool.
