Owner manual

Setup and adjustment CO

transmitter

Required material:

• CO

Transmitter (CF5/8-Series)

• CF5/8 Comm Cable

• ROLINE USB to Serial Converter (Article No. 12.02.1089

)

• Software UIP5 from SenseAir, link

• CO2 CALIBRATOR (for CO

calibration only)

Installation of USB to Serial Converter Cable:

• Insert installation disk and follow the instructions on the screen.

• IMPORTANT: The cable must be configured from COM-Port 1 to 8 (Device Manager)

PAGE 1
Setup and adjustment CO2 transmitter Required material: • • • • • CO2 Transmitter (CF5/8-Series) CF5/8 Comm Cable ROLINE USB to Serial Converter (Article No. 12.02.1089) Software UIP5 from SenseAir, link CO2 CALIBRATOR (for CO2 calibration only) Installation of USB to Serial Converter Cable: • • Insert installation disk and follow the instructions on the screen.
PAGE 2
Hardware Setup: • • CO2 Transmitter must be powered Connect CF5/8 Comm Cable with your computer (USB) and with the CO2 Transmitter Software (UIP5) setup • • • • Start UIP5 , go to menu Help – Check for updates...
PAGE 3
Device setup Outputs The most important settings are Outputs (see outputs tab) Select block No. 3 (PRegulator) to adjust the CO2 scaling. (here 0...
PAGE 4
CO2 (calibration) Select the CO2 tab to calibrate the sensor Connect the CO2 calibrator tube with the sensor (see screenshot) and turn on the device (green light). Wait until to CO2 value is more or less stable. Enter 25(ppm) as Target and push “Calibrate” in the Software. Device is now calibrated.