Instruction Manual

Dokument

IMA 206

Rev

Page

1 (4)

Installation manual

CF5-W, CF5-W-Disp

Dismounting of the sensor

Pull the top part upwards

Push the front part upwards while Fold the front part forwards and

keeping the wall plate steady loose it from the hooks (#1)

1 top part

2 front part

3 wall plate

4 screw

5 label with

settings

inside the

top part

PAGE 1
Installation manual CF5-W, CF5-W-Disp Dismounting of the sensor 4 1 3 2 1 top part 2 front part 3 wall plate 4 screw 5 label with settings inside the top part 5 Pull the top part upwards 1 Push the front part upwards while keeping the wall plate steady Fold the front part forwards and loose it from the hooks (#1) Dokument IMA 206 Rev 1 Page 1 (4)
PAGE 2
Mounting of the sensor A B The wall plate is screwed onto the wall (A) Put the top tabs of the front part into the top holes of the wall plate. (B) Press the lower edge of the case onto the wall plate to latch If the connection cables are drawn through a conduit the conduit must be sealed. Air of different temperature may otherwise disturb the temperature measurements.
PAGE 3
Electrical connections ~ + The power supply has to be connected to and . is considered as system ground. If the analogue output is connected to a controller the same ground reference has to be used for the CF5-W unit and for the control system! Unless different transformers are used, special precautions need to be taken.
PAGE 4
Dimensions and holes 31(1,22) 83(3,26) 120(4,72) Dimensions of sensor in mm and (inches) 30(1,18) 30(1,18) Mounting of the sensor onto the wall 25(0,98) Please use screws with screw head diameter less than 7,5 mm (0,295 inches) and screw head height less than 2,5 mm (0,1 inches) 52,5(2,07) 30(1,18) 2(0,08) 7,8(0,31) 29,8(1,17) 4,2(0,16) Dimensions of mounting plate in mm and (inches) Dokument IMA 206 Rev 1 Page 4 (4)