Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
The antenna of the product, under normal use condition is at least 20 cm
away from the body of the user.
This equipment complies with FCC and IC radiation exposure limits set forth
for an uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
31