Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
Content
Verzeichnis | Répertoire | índice | 目录 | 目次 | 디렉토리
1
Before You Start
Bevor Sie beginnen | Avant de commencer | Antes de empezar | 开始之前 | はじめにお読み下さい | 시작하기 전에
05
2
Drawing and Writing
Schreiben und Malen | Écriture et peinture | Escritura y pintura | 写字绘画 | 字を書く・ 絵を描く| 글씨 회화
08
3
Laser Engraving
Lasergravieren | Gravure laser | Grabado láser | 激光雕刻 | レーザー彫刻 | 레이저 조각
14
4
Picking and Placing
sammeln und zurücklegen | Ramasser et placer | Recoger y poner |
拾取与放置
|
つかむ
・
置く
|
픽커 및 방치
20