Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
Suction Cup Pneumatic Module
Pneumatisches Saugnäpfe-Modul | Module à ventouse pneumatique | Módulo de ventosa neumática |
气动吸盘模块
|
空圧吸盤モ
ジュール
|
공기압 흡반 모듈
2.
Attach the Suction Cup Connector to the Pneumatic Module
Montieren Sie den Saugnäpfe-Stecker am Pneumatikmodul | Installer le connecteur à ventouse sur le module pneumatique |
Instale el conector de ventosa en el módulo neumático | 把气泵吸杆安装到气动模块上 | 吸盤コネクターを空圧モジュールに取り付け
る | 흡반 커넥터를 공기압 모듈에 장착합니다
2
Suction Cup Connector x 1
Hex Nut for Suction Cup Connector x2
1
22