Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
Spin the circle until you get the smallest laser spot
Drehen Sie den Knopf, bis Sie den kleinsten Laserfleck erhalten | Tournez le bouton jusqu'à obtenir le plus petit point laser |
Gire la perilla hasta obtener el punto láser más pequeño | 旋转旋钮直到获得最小的激光斑点 | ボタンを回転して、最小のレーザードッ
トをえる | 가장 작은 레이저 반점을 얻을 때까지 회전 손잡이를 전회합니다
Please be careful and DO NOT touch the laser beam when you focus the laser | Achten Sie beim Einstellen des Lasers darauf, den
Laserstrahl nicht zu berühren | Veillez à ne pas toucher le rayon laser lors du réglage du laser | Al ajustar el láser, tenga cuidado
de no tocar el rayo láser |
在调整激光的时候，请注意安全，请勿触碰到激光束
|
焦点調整中にレーザービームに触れないように十分ご注
意下さい
|
레이저를 조정할 때에는 안전에 주의하고 레이저 빔에 닿지 않도록 하십시오
19