Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
2. Focus Laser Engraver
die Brennweite des Lasermoduls einstellen | Ajuster la longueur focale du module laser | Ajuste la longitud focal del módulo
láser | 调整激光模块焦距 | レーザーモジュールのフォーカスを合わせる | 레이저 모듈 초점 거리를 조정합니다
Wear the Safety Goggles before you set up the laser
engraver and throughout the laser engraving process.
Denken Sie daran, Schutzbrille zu tragen, bevor Sie
beginnen, das Lasermodul einzustellen und die
Laserarbeit zu machen.
Open Rotrics Studio and set the focal height at
the basic panel
Schalten Sie die Rotrics-Software ein und stellen Sie die
Fokushöhe in der Grundplatte ein | Ouvrez le logiciel Rotrics et
réglez la hauteur de la mise au point dans la section de base |
Abra el software Rotrics y configure la altura de enfoque en la
panel básica |
打开
Rotrics
软件并在基本板块设置对焦高度
|
Rotrics Studio ソフトウェアを起動し Basic Panel で焦点距離を設定する
|
Rotrics 소프트웨어를 켜고 기본 플레이트에 초점의 높이를
설정합니다
17