Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
2
Connect to power socket to power on and connect to computer
Schließen Sie das Netzkabel an, schalten Sie die Stromversorgung ein und schließen Sie den Roboterarm an den Computer an |
Branchez le cordon d'alimentation, allumez l'alimentation et connectez le bras à l'ordinateur |
Enchufe el cable de alimentación, enciéndalo y conecte el brazo a la computadora | 插上电源线,打开电源并将机械臂连接到电
脑 | ACアダプターを接続し、電源をオンにしてからロボットアーム本体を PC に接続します | 전원 코드를 꽂고 전원을 켜고 기계 팔을
컴퓨터에 연결합니다.
2
1
9