Quick Start Guide
Table Of Contents
- To use the 3D printing module, please read the corresponding guide.
- Tools & Accessories Cables & Power Adapter
- Pneumatic Kit
- Before You Start
- Robot Arm Coordinate System
- Y
- Ports
- 1 2 3
- External Motor Port
- USB-C Ports
- Setup Pen Holder Module
- Connect to power socket to power on and connect to computer
- Use Pen Holder Module
- Start drawing
- Adjust pen height
- Open Rotrics Studio and click Basic
- Start Drawing
- Generate G-code
- Laser Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Start Engraving
- Transform into a Laser Engraver
- Prepare for Laser Engraving
- Place the material
- Focus Laser Engraver
- Open Rotrics Studio and set the focal height at the basic panel
- Start Engraving
- Please refer to our online manual for more details: manual.rotrics.com
- Generate G-code
- Picking and Placing
- Transform into a Air-Picker
- Start Picking and Placing
- Attach the universal pneumatic connector to the pneumatic module.
- Suction Cup Pneumatic Module
- Attach the Suction Cup Connector to the Pneumatic Module
- Attach Suction Cup
- Soft Gripper Pneumatic Module
- Start Picking and Placing
- Please refer to our online manual for more details: manual.rotrics.com
- Open Rotrics Studio and record movements
- Generate G-code and start picking
- Support
Ports
Schnittstelle | interface | interfaz |
接口
|
端子
|
인터페이스
Power Port
Power-Schnittstelle | Interface de puissance | Interfaz de energía | 电源接口 | 電源端子 | 전원 인터페이스
1 2 3
12V
External Motor Port
Externe Schrittmotor-Schnittstelle | Interface de moteur pas
à pas externe | Interfaz externa del motor paso a paso |
外部
步进电机接口 | 外部ステッピングモーター端子 | 외부 스테퍼
모터 인터페이스
USB-C Ports
USB-C-Schnittstelle | Interface USB-C | Interfaz USB-C |
USB-C
接口
| USB-C
端子
| USB-C
포트
7