DigiTemp Digital Thermometer R (Standard Version) Instruction Manual
DigiTemp Digital Thermometer Instruction Manual R Page 1 The DigiTemp battery-powered digital thermometer is designed to suit a wide range of industrial applications which demand accurate measurement of temperature. The DigiTemp is housed in a robust stainless steel case, sealed to IP67 rating, which is suitable for hostile industrial environments without additional protection. Powered by two standard AA alkaline cells, the DigiTemp gives two years of continuous maintenance-free operation.
DigiTemp Digital Thermometer Instruction Manual R Page 2 Battery replacement The instrument is powered by two alkaline manganese 1.5 volt cells, type LR6 (AA). When these are due for replacement the display will alternate between the temperature reading and message bAtt. This warning will be given when the battery voltage falls to 2.0 volts (1.0 volt per cell), at which point the battery has approximately two months' life remaining.
DigiTemp Digital Thermometer Instruction Manual R Page 3 Calibration (continued) 4. Refit the dial, place the sealing gasket on the front face of the case then centre the window on the gasket. Refit the bezel ring tightly with firm hand pressure. CAUTION! Observe correct safety procedures when working with high temperature calibration baths.
DigiTemp Digital Thermometer Instruction Manual R Page 4 Specifications Sensor: Platinum RTD or thermocouple (Type K class 1 as standard, others available to order) Measurement ranges: T/C: -100 to +1000°C (-148 to +1832°F) 1° resolution RTD: -50 to +200°C (-58 to +392°F) 0.1° resolution (Specific temperature range is dependent on sensor & stem construction) Accuracy: T/C: ±1°C ± 1 digit RTD: ±0.2°C ± 1 digit Stability: T/C: RTD: Zero Span Zero Span : : : : ±0.05°C per °C ambient change ±0.
