Specifications

RotorWay International

Exec 162F Maintenance Manual

14. Removal of the throttle grip is easily done by placing an air hose nozzle into the hole on the front of the rubber grip and

blowing air into the grip at a high velocity. The grip will expand and can be pulled off. Note: Do not cut off any length

of the rubber grip. The part of the grip that extends past the throttle and onto the non-rotating part of the collective stick

will help act as a friction lock for the throttle. Removal of the throttle shaft is done by removing the bolt (part no. E00-

2306) and the “B” control arm castings (part no. E15-5110). Slide the throttle shaft completely out of the pilot collective

stick. Place a small amount of grease on the throttle shaft (part no. E15-3150) and also on the plastic bushings. Re-

install the throttle shaft back in the collective stick and rotate several times until the throttle moves freely. Finish

assembly.

15. Remove bolts (part no. E00-2407). Measure center of rod ends on Throttle Connector (part no. E15-3160). Loosen

lock nuts and count the number of turns to remove the rod ends(part no E15-1150). Install new rod ends using the

same number of turns and check center line measurement. Confirm throttle settings by referring back to the Construction

Manual.