Specifications
RotorWay International
Exec 162F Maintenance Manual
16
Rev. 1 6/04
3. Remove bolt (part no. E00-2311) and two washers. Then slide the actuator arm to one side and place a small amount
of grease on the bolt hole in the pivot casting. Reassemble the actuator arm, install bolt, and check the nut with cotter
pins for security.
4. Every 50 hours, add grease to the fitting on the tail rotor barrel until the grease comes out near the pitch horns, and
wipe off excess. Drill a 3/16 inch hole in each blade tip cap so that grease thrown out by centrifugal force will not build
up inside the blade.
5. Slowly inject one shot of Mystik JT-6 grease while moving the slider back and forth to spread the grease evenly. Add
grease again every 25 hours of operation or as needed.