User's Manual

47ROTOR INspider training use
ES
EN
7. ROTOR INspider TRAINING USE
After pairing ROTORyour power meter, follow the configuration options for your cyclecomputer
to select the metrics you would like to display on your device.
Consult your trainer in order to evaluate which of the measured values provided by ROTORpersonal
INspider are optimal to maximize your performance.
ROTOR INspider MEASUREMENT
ROTOR starts measuring data automatically when pedaling. The following data areINspider
sent by radio signal to your head unit:
POWER: p computer deviceower of the last complete pedal cycle. The power displayed on your
is the combined total power applied by the two legs.
Remove any cadence sensor from your bike, it is not necessary and may cause interference.
Turn off the cadence sensor on the monitor; this will be displayed thanks to your power meter.
WARNING!
Manual_ _ES_EN2INpower
CADENCE: measured in RPM’s (revolutions per minute).
BALANCE: the spider-based power meters
estimate balance numbers. Balance provides
information about how much power is applied
by each leg. It is shown as two complementary
percentages (e.g.: 52%-48%).
OCA - 90º
OCA + 90º
Inspider takes as a starting point for the power
applied by the right leg the point that comes
90º before the OCA number, and as finishing
point the one that comes 90º after OCA. It is
considered that the remaining part of the
complete cycle is produced by the left leg only.
Right leg
semi-cycle
Left leg
semi-cycle
OCA