User's Manual

STEP 11

Select the ‘Start Channel’ DMX address number you

would like the ﬁxture to be located at (typically Ch1)

STEP 12

A range of sliders will automatically be added to your

project.

STEP 13

Now click the green or red circle in the top right of the

Luminair app to bring up the network status page.

STEP 14

Select the Bluetooth tab. You should see a list of all

available BLE devices here. By default the Titan will

appear as ‘Rotolight Titan X2’ (you can change the

displayed name via the CRMX Toolbox app). In the

screenshot below the Titan is named ‘DevTitan’.

STEP 15

Tick the Titan unit which you want to control.

STEP 16

This should connect to the Titan and the DMX status

page should change to green as shown

STEP 17

The 'STATUS' page on Titan should now display in green,

showing a good signal from Luminair.

TIPS

1) SOMETIMES THE LUMINAIR APP WILL USE A START ADDRESS OF 2 INSTEAD OF 1 -

CAUSING A MISALIGNMENT OF THE CHANNEL MAPPING.

TO CORRECT THIS ON THE LUMINAIR APP, CLICK ON THE FIXTURE NAME IN THE TOP LEFT OF THE DISPLAY

THEN CLICK EDIT. THEN CLICK THE BOX THAT SAYS CH2 AND CHANGE TO CH1. DISMISS THE SETTINGS BY

CLICKING THE EYE SYMBOL ON THE RIGHT THEN SHOW ALL FIXTURES.

2) ENSURE THAT THE SFX SELECT CHANNEL IS SET TO ZERO TO TURN OFF THE SPECIAL EFFECTS.

STEP 13

STEP 15

STEP 17