User's Manual

40
HOW TO CONNECT TO LUMINAIR
STEP 1
Ensure your Titan has the latest firmware installed via the USB
update process. At the time of writing this is V200_201
STEP 2
Ensure you also have the latest LumenRadio firmware installed
via the CRMX toolbox app. At the time of writing this is v1.0.1.0
STEP 3
Power on your Titan
STEP 4
Select DMX / IN/OUT - INPUT = WIRELESS, NETWORK =
LUMENRAD
STEP 5
Now go to the STATUS tab in the DMX menu - at this stage
this should display a red no-signal indication since we have not
yet setup Luminair
STEP 6
If you have a Titan project loaded and have previously
controlled your Titan from it - the app should automatically
connect to your Titan at this point (this may take up to 10
seconds), at which point the DMX status screen will turn green
and show the signal info.
STEP 7
If you are starting with a blank Luminair installation, then you
will first need to create a new Luminair project and add the
Titan X2 fixture to the project as follows:
STEP 8
On Luminair, select the menu icon in the top left and select
‘Projects’ then click ‘+’ to add a new project.
Enter your project name.
STEP 9
On the blank project page - click the ‘+’ in the top left to add
a fixture. Select ‘DMX fixture / Select a Profile’, scroll down the
list of manufacturers to Rotolight then select TitanX2 (Note: it
may be necessary to first download a fixture file for Rotolight
before you see Rotolight in the list of manufacturers).
STEP 10
Select the mode you would like to run the light in. eg. Titan X2
Mode 1A (CCT)
STEP 1
Welcome to Titan version xxxxx
STEP 4
STEP 5
STEP 9
INPUT OUTPUT NETWORK
LOCAL CTRL
DMX CABLE
WIRELESS
SYNC-SFX
WIRELESS
DMX CABLE
UNLINK
ROTOLIGHT
LUMENRAD
NO SIGNAL
DMX
Addr
1