User Manual
Page 8
When you turn on an ANOVA , with the WIFI turned –on, it will create a network (no
third party equipment, eg router, required). When you turn on the next ANOVA it
will check to see if the rst ANOVA has the same PIN and if a network exists, and
then it joins that specic network. Your iPhone or iPad also become ‘clients’ of that
specic ANOVA network. Only one (authorised by WEP password) control client
(iPhone/iPad) can be connected to an ANOVA network.
If you need to run multiple simultaneous ANOVA networks it is a very good idea to
provide as much WiFi channel separation as possible, i.e. use WiFi channels 1, 6, 11.
This will avoid interference between the channels. If you are only using one
network, then you can choose any appropriate wi channel , i.e. 1,2,3,4,6,7,8,9,11.
The Anova will have been set to provide you with an appropriate range of legal wi
channels for your country (of purchase). Please refer to local legislation as to which
channels are legal in your territory prior to operation.
If you have forgotten your PIN setting or simply wish to start over with a simple
setup, powering up the ANOVA whilst depressing the encoder switch will bring
up the DIST (Distributor) menu, and you can reset the factory default settings by
choosing ‘-yes’. The PIN will now be set to ‘1AAA’ and the WEP Password for your
iPad/iPhone will be ‘01AAA’ . You will also need to select CNTL – wi to run the light
from the Magic Eye App.
Anova_User_Guide.indd 8 04/05/2012 14:03