User Manual

Page 10
the recommended AC/DC adapter. Never exceed the recommended Voltage (13-
17 volts DC). Make sure you use the ‘XTRA Strap’ cable ties to secure the Power
connector / adapter to your light stand, so there is no strain on the 2.1mm DC
Socket, otherwise damage may occur to the socket.
Utility Blocks
Use these to connect the Yoke, or Barn Doors. There are additional mounting holes
on the rear face and either side of the main mounting point, these can be used to x
the T-Bar connector plates which join the lights together. ANOVA is designed with
an outer ‘Honeycomb’ shape so it can easily be ‘tesselated’ into a panel/wall/ring of
lights. Rotolight Inc at Pinewood Studios, England ([phone]) are happy to
quote on custom Yokes for larger arrays of ANOVA lights.
The ANOVA Yoke is tted with a ‘TVMP’ (TeleVision Motion Picture) bracket. This
will t a standard ‘Junior’ Lighting support stud as used in lm and televison studios.
The TVMP Bracket on the ANOVA has two positions for the retaining screw, The
higher position is for a Junior stud, the lower position is so you can mount the
Anova on a 3/8 stud on a normal studio lighting stand (Please check that the stand
is designed to take the weight of the Anova rst ! 3.2 Kilos without barn doors / 4.7
Kilos with the Barn Doors Fitted)
V-Lock Battery Plate
Connect standard (14.4 volt) V-Lock Batteries or Anton Bauer Goldmount Batteries
with a QR-A200 plate adapter. To release the battery, press the button on the
bottom of the plate.
7
8
Anova_User_Guide.indd 10 04/05/2012 14:03