User Manual

Rotate the right knob to adjust the fade duration
(It will display DN (=fade down) followed by a numerial
value ‘X’s where X = seconds of fade duration)
The fade can be from 1 to 12 seconds long.
Please note, the FADE will be a fade to zero from the
current brightness level the NEO is set to (ie if brightness
is currently 80%, then fade will be 80%-0% over custom
time duration).
(NB: both the last used brightness setting and fade
duration parameter are stored in non volatile memory)
Once you have selected the length of the fade, Click the
right switch to perform the fade.
You will notice the display now shows UP X s (i.e. it will
now fade up to your previous brightness setting over ‘X’
seconds)
To fade up click the Right switch again
If you only want Fade downs’ use the Left switch to click
out of FADE and click back in – use the right switch to
perform the Fade.
Click the left switch to return to MENU, alternatively you
can return to the basic operation menu (BRI / COL) by
pressing both control switches together.
(‘F-DIM’) TRUE APERTURE DIMMING ™
(Shows the brightness setting as an accurately calculated
aperture (F-Stop) for your subject at a given distance.)
Cycle the menu to ‘F-DIM’ then Click the right switch to
enter ‘F-DIM’ mode.
Rotating the left knob cycles through the available user
parameters:-
‘ISO’ (your camera ISO setting), ‘EXP’ (your camera
shutter speed) and ‘FEET’ (the distance from the light to
your subject in feet)
Rotating the right knob will adjust the selected user
parameter (ISO/EXP/FEET)
Clicking the right switch will enter the ‘F-Stop Dimming
Display’ where the brightness is dynamically displayed as an
aperture or ‘F-Stop
- 07 -