User Manual

ADVANCED OPERATION ( MENU )
You can enter the MENU by pressing both red control
switches together (or clicking and holding down the left
switch followed by the right control switch). If you wish
to leave MENU, you can return to the basic operation (BRI
/ COL) by pressing both control switches together again.
In the MENU there are seven optional submenus , which
you can select by rotating the left knob:- ‘DISP’ , ‘FADE’ ,
‘F-DIM’ , ‘SFX ‘, ‘VOLT’ , ‘TEMP’ , ‘VERS’
You can enter your selected function by clicking the Right
switch
You can leave the selected function by clicking the Left
switch, alternatively you can return to the basic operation
mode (BRI /COL) at any time by pressing both switches
together at the same time.
(‘DISP’) DISPLAY
Allows the display to be set to low brightness or ‘off’ to
reduce power consumption/increase battery life or for
discrete usage on set.
Click the left switch to enter ‘DISP’
Rotate either the left or right knob to select the display
mode:-
‘High’ – the display will be at full brightness
‘Low’ – the display will be dim, reduced power
consumption
‘Off’ – The display will automatically switch off after 5
seconds unless a control is operated for maximum power
saving.
Click the left switch to return to MENU, alternatively you
can return to the basic operation (BRI / COL) by pressing
both control switches together.
(‘FADE’) DESIGNER FADE™
(Programmable fade up / fade down production effects for
interview/ ENG applications.)
Scroll to ‘FADE’
Click the right switch to enter ‘FADE’ mode
- 06 -