User Manual

(‘TV’) TELEVISION
This effect is an emulation of someone watching a TV show – it
works best by adding the 116 Medium blue/green lter from
the Add on Colour FX Pack.
Click the right switch to activate the TV effect
Rotate either the left or right knob to adjust the TV
effect speed (It will display XX hz , which will give you an
indication of the effect speed)
Click the right switch to pause the effect / fade to black -
‘Trig’ will be displayed - re-Click the right switch again to
Trigger the effect. (NB: the TV parameters are stored in
non volatile memory). Click the left switch to exit the TV
effect and return to SFX Menu.
(‘VOLT’) VOLTAGE
VOLT mode will scroll display the voltage from the
selected power source. (e.g ‘9.4V BATTERY’ or ’15.2V
DC IN’). Please note NEO will automatically give you a
warning if the voltage drops too low which indicates a
battery change is needed (e.g. ‘Low Battery’) . NEO will
also put a blinking dot on the bottom right of the current display
to indicate Low Battery Voltage whilst reducing the output by
progressive steps of 10% until voltage stabilises to eliminate icker.
NEO will operate from 6V DC up to 17.5V DC. Only
connect external power sources with the correct polarity
and voltage to avoid serious damage to NEO.
(In ‘VOLT’ mode, to check your battery performance in action,
you can click the right switch and then rotate the left knob to
observe the actual battery voltage during the range of dimming)
Click the left switch to return to MENU, alternatively you
can return to the basic operation (BRI / COL) by pressing
both control switches together.
(‘TEMP’) TEMPERATURE
Click the left switch to display the internal operating
Temperature of NEO. NB: if NEO detects the battery
temperature rising to 58 degrees or above, it will display ‘Too
Hot’ (touch any knob to clear message) and automatically
cut the output down to 25% to prevent overheating.
(Please use only quality battery systems inside NEO)
Click the left switch to return to MENU, alternatively you
can return to the basic operation (BRI / COL) by pressing
both control switches together.
- 13 -