User Manual

to avoid damaging your NEO 2. For best results use

the Rotolight ‘Powerex Pro’ LionHeart AA batteries

and charging systems, these are the most powerful

NiMH AA rechargeable available (2700mAh) and

are designed for demanding systems like the NEO2,

or ‘Eneloop PRO’ AA batteries. Alternatively use the

Rotolight RL-Batt-95, 95mWh V-Lock batteries with

Dtap cable (available from Rotolight.com) which

will run your NEO 2 for up to 8 hours at full power.

To power up NEO 2 click the power switch (located

above the ‘FLASH’ input Jack)

On power up, you will see ‘ROTOLIGHT NEO 2’ scroll

across the screen, you can interrupt this anytime by

operating one of the control knobs.

To power NEO 2 down , click the power switch

again. NB – NEO 2 stores and will recall your last

used settings.

RESET

You can reset all the user parameters in NEO 2 by

holding down the left red control switch whilst

simultaneously powering NEO 2 ON. This resets all

the parameters to the factory default settings.

The word ‘ZERO’ will be displayed, select Y for yes

(reset all data), or N for NO.

BASIC OPERATION MODE (BRI / COL)

(‘BRI’) BRIGHTNESS

You can adjust the brightness output of NEO 2 by

rotating the left control knob.

If you rotate the knob quickly it will speed up the

data input. You can press and rotate to deliberately

adjust the brightness in steps of 10% (Fast Mode).

Simply rotating the knob will adjust the brightness

in steps of 1%.

NEO 2 has a dimming range of 0% -100% and is

completely ﬂicker free at any brightness level,

shutter speed or frame rate.

BRI