User Manual

item (this way you can select or remotely trigger
Fades or the CineSFX items).
(‘DISP’) DISPLAY
Allows the display to be set to low brightness or ‘off’
to reduce power consumption/increase battery life
or for discrete usage on set.
Click the right switch to enter ‘DISP’
Rotate the left knob to select the display mode:
‘High’ – the display will be at full brightness
‘Low’ – the display will be dim, reduced power
consumption
‘Off’ – The display will automatically switch off after 5
seconds unless a control is operated for maximum
power saving or discretion on set.
Click the left switch to return to MENU, alternatively
you can return to the basic operation (BRI / COL) by
pressing both control switches together.
(‘FADE’) DESIGNER FADE™
(Programmable fade up / fade down for practical
‘in-camera’ production fade effects)
Scroll to ‘FADE’
Click the right switch to enter ‘FADE’ mode
Rotate the right knob to adjust the fade duration
(range is up to 12 seconds up or down)
(It will display DN (=fade down) followed by a
numerical value ‘X’s where X = seconds of fade
duration)
The fade can be from 1 to 12 seconds long.
Please note, the FADE will be a fade to zero from
the current brightness level the NEO 2 is set to (i.e. if
brightness is currently 80%, then fade will be 80%-
0% over custom time duration).
(NB: both the last used brightness setting and
fade duration parameter are stored in non volatile
memory)
Once you have selected the length of the fade, click
the right switch to perform the fade (you can also
trigger the fade using an external flash trigger via
the FLASH sync port).
23
DISP
FADE