User Manual

(SKYPORT), this activates the SKYPORT wireless

HSS trigger. (NB: NEO2 will also still ﬂash in Skyport

mode from a wired external source connected to

the Flash Synch 3.5mm Jack port)

Rotate the left knob to scroll to ‘GRP’ (SKYPORT

Group)

Click the right switch to enter ‘GRP’ settings

Rotate the right knob to select your desired group

(GP 1-4)

Click the left knob to set and return

Rotate the left knob to scroll to ‘FREQ’ (SKYPORT

Channel)

Click the right switch to enter ‘FREQ’ settings

Rotate the right knob to select your desired Channel

(Ch 1-20)

Click the left knob to set and return

Rotate the left knob to scroll to ‘TEST’ (SKYPORT

Trigger Input Monitor)

Click the right switch to enter ‘TEST’, ‘0 . 0’ is

displayed

SETTING UP THE HS TRANSMITTER

First turn on your NEO 2, then turn after a few

seconds, turn on your Rotolight or Elinchrom HS

Skyport Plus HS Transmitter ( the latter requires a

free ﬁrmware update required from Elinchrom.

com).

In the setup menu, scroll down to ‘ELSP’ and within

that sub menu, rotate the rotary wheel to ‘Speed’

Mode, and press the centre button (inside the rotary

wheel) to activate speed mode (The transmitter

display should turn red)

Next, in the Setup menu, scroll down to ‘Sync Mode’

and within that sub menu, rotate the rotary wheel

to ‘HS’ (for High Speed) Mode, and press the centre

button (inside the rotary wheel) to activate speed

mode (HS will be displayed on the screen – note

Sync menu does not appear in Nikon transmitters

and is not required to be activated for HSS)

The Rotolight HSS transmitter by Elinchrom will

default to Group 1, channel 1, same as NEO 2. When

SKYP