User Manual

Rotate the right knob to set the desired duration

for the ﬂash, in shutter intervals, i.e. 1/50s, 1/60s,

1/80s, 1/100s…up to 1/1000s (‘1/1K0’). TOP TIP : NB –

*recommended* you can just leave the duration set

to 1/50th and NEO 2 will automatically adjust the

duration for you if the number of frames per second

requires a shorter ﬂash.

Press, hold and rotate the right hand knob to

set the ﬂash output power, ‘MAX’ (=250% of MAX

continuous output), ‘1/2’ (=125%), ‘1/4’ (=62%), ‘X8’

(=modelling light level x 8), and ‘X16’ (= modelling

light level x 16). NB - when an external 15v power

source is connected (such as the AC adapter or

V-Lock battery) the NEO will automatically raise

the ﬂash output power to ‘MAX +’ ( = 500% of the

normal continuous maximum output, or 1 x f-Stop

more ﬂash power )

To trigger the ﬂash from your Camera (wired

operation), connect a PC sync cable from your

camera’s PC sync port to the 3.5mm mono jack on

the NEO 2. (If your camera does not have a PC sync

port, then you can purchase the optional ‘Rotolight

Accessory Shoe to PC’ adapter and the PC Flash

sync cable, which converts your accessory shoe into

a PC socket).

NB : PC sync is limited to your camera’s internal

sync speed (usually 1/60th up to 1/250th). IT IS NOT

HIGH SPEED SYNC

Rotolight HSS trigger by Elinchrom :

To shoot in High Speed Sync , you will need an

HSS wireless transmitter, such as the Rotolight or

Elinchrom HSS transmitter (both are compatible

with the internal receiver inside the NEO 2)

Using third party Triggers :

Alternatively, you can connect third party ﬂash

receivers or transceivers which have a PC sync or

3.5mm ﬂash output, with a PC sync/3.5mm cable

to the 3.5mm mono jack FLASH Trigger input jack

located on the rear of NEO 2. Use the provided Cold