User Manual

(NB There is a special mode called ‘True Aperture

Dimming’ (F-DIM) , available in the MENU section,

which will display the brightness as an F-Stop

(Aperture), based on your camera exposure settings

– see ‘True Aperture Dimming’)

(‘COL’) COLOUR

You can adjust and accurately display the Colour

Temperature (CCT) of NEO 2 by rotating the right

control knob.

If you rotate the knob quickly it will speed up the

data input. You can press and rotate to deliberately

adjust the colour in steps of 100 kelvin (Fast Mode).

Slowly rotating the knob will adjust the brightness

in steps of 10 kelvin.

NEO 2 has a Colour Temperature Range of 3150

kelvin (Tungsten) up to 6300 kelvin (cloudy/

overcast).

Note : For maximum brightness, as a Bi Colour light,

NEO 2 will be brightest at the ‘mid point’ colour :

roughly 4100 Kelvin, where both sets of LEDs are at

full power. This also applies in ﬂash mode. When

mid point colour is set, a small dot will appear in

the Red window of the NEO2.

NEO 2 has a special technology called ‘Dynamic

Drift Stabilisation’™ which maintains the colour

temperature through the entire dimming range.

( MENU ) ADVANCED OPERATION

You can enter the MENU by pressing both red

control switches together (or clicking and holding

down the left switch followed by the right control

switch). If you wish to leave MENU at any time,

you can return to the basic operation (BRI / COL) by

pressing both red control switches together again.

In ‘MENU’ Mode the left rotary control is Navigation,

and the left switch takes you ‘back’ one level. The

COL