User's Manual

Table Of Contents
Click on the “Frequency (MHz)” box and then type the desired Frequency in
Mega Hertz in the box for both the transmit (TX) and receive (RX) boxes.
ation and confirm that the
desired frequency was accepted.
or later), click the box
“Is EUT a Test Box” and perform the steps outlined above.
10.7.4. End of Programming
, perform a “Read” operation and
confirm all of the fields are entered as intended.
Press the “Verify” button. This causes the unit to verify the integrity of all the data
hen all the changes are confirmed and verified, test the system by following the
Bench Test Procedure in Section 4.3.
Allowable entries are in the range of 150 to 174 Mega Hertz.
CAUTION Changes to the TX operating frequency by more than 2 MHz on either
side of the original frequency require retuning and must be performed by an authorized
service center.
Press the “Enter” Key or click the mouse to another box.
Click the “Read” button to re-read the Unit inform
To change the frequency of the RFD Text Box (Version 2.0
When programming has been completed
stored in the unit’s memory. Reprogram any fields that fail and re-verify.
W
1678 RFD OPERATION MANUAL {DRAFT}
80