User's Manual

Table Of Contents

10.7.1. Changing the System Address

rogrammable only on Remote and RSTI Units. It may not be

changed on Mini Controller Units. The System Address should only be changed by

personnel having that authority. A possible scenario for changing the System Address

is that a Remote Unit in system 12345 has become unserviceable. A Remote Unit from

another system may be reprogrammed to have a System Address of 12345 to complete

the system. The Unit Number for the replacement Remote Unit should be

reprogrammed to match the Unit Number of the Remote Unit it is replacing.

To change the System Address follow the listed steps.

• Click on the “System Address” box and then type the desired System Address in

the box. Allowable entries are in the range of 1 to 65535.

• Press the “Enter” Key or click the mouse to another box.

• Click the “Read” button to re-read the Unit information and confirm that the

desired System Address was accepted.

10.7.2. Changing the Unit Number

The Unit Number is used to assign a unique

hin a

ck the mouse to another box.

• Click the “Read” button to re-read the Unit information and confirm that the

Units,

STIs, and RFD Test Box use to communicate with each other. All Units within a

o change the Frequency, follow the listed steps.

The System Address is p

ID to each Remote Unit within a system.

The same Unit Number should not be assigned to more than one Remote Unit wit

system.

To change the Unit Number follow the listed steps.

• Click on the “Unit Number” box and then type the desired Unit Number in the

box. Allowable entries are in the range of 1 to 8.

• Press the “Enter” Key or cli

desired Unit Number was accepted.

10.7.3. Changing the Frequency

The Frequency is the radio frequency that the Mini Controller Unit, Remote

system must have the same Frequency.

1678 RFD OPERATION MANUAL {DRAFT}