User's Manual

Table Of Contents

5.2.4. If using the RSTI, proceed to Section 5.2.7. After performing standard

demolition circuit checks and before placing initiator into the main charge, depress the

two spring-loaded binding posts on the Electric Remote Unit.

5.2.5. Insert one leg of the demolition wire in each binding post and allow the

binding posts to close on the wire ends.

5.2.7. Install the non-electric shock tubing onto the Shock Tube Tip and mount the

tip

5.2.8.

cated more Error! Reference source not found.

than from the Mini Controller Unit, refer to section 5.3.11.

i Controller Unit, and other Remote Units are more than Error!

Reference source not found. from the Mini Controller Unit, refer to section 5.4.11.

STEM OPERATION – REMOTE UNITS WITHIN ERROR! REFERENCE

5.2.6. Ensure the wire is held securely by the binding posts and that the wire ends

are not touching the Electric Remote’s case or each other. Proceed to Section 5.2.8.

onto the RSTI according to Section 2.6. Take care to ensure no moisture or debris

enter the shock tube or contact the Shock Tube Tip’s needle

Prepare the shot and return to the safe firing area.

5.2.9. If all Remote Units are located within Error! Reference source not found. o

the Mini Controller Unit, refer to section 5.2.11.

5.2.10. If all Remote Units are lo

5.2.11. If some Remote Units are located within Error! Reference source not

found. of the Min

5.3. SY

SOURCE NOT FOUND. OF MINI CONTROLLER UNIT

Note: If the distance between the Mini Controller Unit and the Remote Units is in

ions

erence source not found. of the Remote Units. The only

difference is the method the status indication Unit

nits

ntroller Unit display panel to indicate the Mini Controller Unit did

not receive a status message from the Remote Unit. Once the Remote Units are set up

for

excess of Error! Reference source not found., the Remote Units status transmiss

may not be received by the Mini Controller Unit. The Mini Controller Unit will command

the Remotes from a distance greater than Error! Reference source not found., but t

Remote Status may not be confirmed. The Mini Controller Unit performs just as it would

when it is within Error! Ref

s are displayed on the Mini Controller

display panel. The ARMED and DISARMED status lights for out of range Remote U

will flash on the Mini Co

the shot, the operator must assume the Remote Units have received the command.

5.3.1. Ensure the area is clear.

5.3.2. Turn the Mini Controller Unit on.

1678 RFD OPERATION MANUAL {DRAFT}