User's Manual

Table Of Contents
2.8.2. Serial Communications Port: The Test Box can be connected to a serial
RS-232 port on a host PC. The connection can be used to log the results of the tests
performed. The serial communications port is also used when performing parameter
changes.
Figure 2-10 Test Box
2.8.3.
2.8.4.
Test Probe: The Test Probe connects to the antenna/charge connector on
the top of the Mini Controller, Electric Remote, or RSTI. Through the Test Probe, the
Test Box communicates with the test unit to read the various settings, parameters, and
to measure firing circuit and loaded battery voltages.
LCD Display: The LCD displays information both from the Test Box itself
during its power on sequence, and while reading and testing a Mini Controller, Electric
Remote, or RSTI. The LCD’s backlighting will turn on while the unit is active. The
information that may be displayed on the LCD is listed below:
Serial Number
Date of Manufacture
System Number
Unit ID
Frequency Assignments
Firmware Checksum and Version
1678 RFD OPERATION MANUAL {DRAFT}
20