User's Manual

2.4.6.
2.4.7.
2.4.8.
2.4.9.
2.4.10.
2.4.11.
2.4.12.
Remote Unit Armed: A red light next to each of the “1” though “4” switches
is used to indicate when the corresponding Remote Unit is armed. The ARMED light for
selected Remote Units will flash after the Arm command is sent to the selected Remote
Units. The ARMED light will go to steady after the firing capacitor charge time if the
Mini Controller Unit is within range of the selected Remote Unit's transmitter. If the
Remote Unit transmitter is out of range of the Mini Controller Unit, the ARMED light will
continue to flash.
Status: A yellow light at the “STATUS” switch lights when the “STATUS”
switch is pressed. The light remains on until the display panel has been updated with
results of the status request. All new commands are blocked while this light is on.
Arm: A yellow light at the “ARM” switch lights when the “ARM” switch is
pressed. This light will stay on for the firing capacitor charge time.
Disarm: A yellow light at the “DISARM” switch lights when the “DISARM”
switch is pressed. This light will stay on until the display panel is updated for the Disarm
command. Other commands will not be sent until this light is turned off.
Fire: A yellow light at the “FIRE” switch lights when the “FIRE” switch is
pressed. This light will stay on until the display panel is updated for the Fire command.
Other commands will not be sent until this light is turned off.
“TX” (Transmit): A red light at the “TX” position lights while Mini Controller
Unit is transmitting. Switch presses (DISARM, STATUS, ARM, FIRE, and 1-4) are not
recognized while the Mini Controller Unit is transmitting.
“RX” (Receive): During operation the green “RX” light turns on while
receiving a status response from a Remote Unit. The RX light will also turn on in the
presence of another on channel radio signal or from background radio noise.
1678 RFD OPERATION MANUAL {DRAFT}
11