User's Manual

1678 RFD OPERATION MANUAL 76
4. Push the tab on the 3-wire battery connector plug and gently pull to release it from
the receptacle.
5. Gently pry the battery pack from the main body.
6. Replace battery pack with the new pack. Carefully route the wires to the inside of
the seal wall to prevent pinching when the case is closed. Snap the battery pack’s
3-wire plug into the connector housing. Install the cable tie as shown to ensure the
battery pack does not detach under mechanical stress. Trim the excess portion of
the cable tie.
7. Replace the seal using the new seal supplied in the kit. Ensure the seal groove
and the battery lid’s sealing surfaces are clean and dry. The seam in the seal
should be oriented toward the straight part of the case at the top.