User's Manual

1678 RFD OPERATION MANUAL 68
9. Open the Advanced tab and make sure the Load VCP box is checked. It maybe
necessary to disconnect and reconnect the USB cable to refresh the list.
10. Note the COM number that has been assigned to the Test Box. The COM number
will be necessary when connecting to the RFD HS Terminal Utility Software.
11. Note that the COM port assigned to the Test Box may change if the USB cable is
plugged into a different USB port on the computer.
12. Before starting the RFD HS Terminal Utility, connect the USB cable from the 1678-4
RFD Test Box to a USB port on the PC.
13. Open the RFD HS Terminal Utility program and select the COM Port that was
assigned by the computer’s Hardware Manager to the Test Box.