User's Manual

1678 RFD OPERATION MANUAL 59
After testing is complete, the Controller’s loaded battery voltage is displayed.
9.1.3. Testing the Electric Remote
WARNING Do not touch the firing terminals of the Remote units while testing. A
potentially lethal voltage is present during the Fire test.
To test an Electric Remote, plug the Test Box probe into the top connector on the
Electric Remote. The Electric Remote turns on with the yellow light fast blinking and the
green light on. The Test Box will display the following message.
Next the Test Box will display the Battery Charge Count as shown below. This is the
number of charge cycles the battery within the Electric Remote has experienced.
Next the Test Box displays the current battery’s temperature (+22C +72F) and
chemistry type (NiMH).
The next message shows the battery serial number (Battery SN 0001) and the battery’s
date of manufacture (Battery DOM 02/03/2011).
Battery Temp +22C +72F
Battery Type: 1650mAh NiMH
Battery SN 0001
Battery DOM 02/03/2011
Battery Charge Count
83
Electric Remote Detected
Battery Voltage 7.24