User's Manual
1678 RFD OPERATION MANUAL 10
• Depress “ARM” switch – all Remote Units will arm.
• Depress the switches for the Remote Units that will not be fired initially.
• Depress the “FIRE” switch. Only Remote Units still selected will fire.
• Depress the switches for the Remote Units that were just fired.
• Depress the switches for Remote Units to be fired next.
• Depress the “FIRE” switch. Only Remote Units still selected will fire.
• Repeat as necessary. Remote Units will automatically disarm if not fired within the
Arm Time Period.
2.4.11. Misfires: If a Remote Unit does not fire when the Fire command is sent,
repeat the fire sequence up to 3 times. If the Remote Unit continues not to fire, then a
thirty-minute wait prior to approaching is mandatory. Follow your standard operating
procedures for misfires.
2.5. CONTROLLER DISPLAY OPERATION
2.5.1. Night time Panel Switch Locator: There are 10 or 14 red lights used for
backlighting the Controller switches. When the Controller is powered on, the lights
turn on to help locate the switch positions.
2.5.2. Display Panel Dimmer Circuit: Repressing the ‘ON’ switch toggles the
LED display light’s intensity between bright and dim. When the unit is turned on, the
last chosen intensity setting is restored.
2.5.3. Mini Controller Unit Battery Status: The yellow light at the “ON” switch
displays the Mini Controller Unit BATTERY status. If the Mini Controller Unit battery is
low, the yellow light at the “ON” switch will flash. Otherwise this light will be on steady.
2.5.4. Controller Unit Battery Status: The yellow “BAT” light at the top of the
Controller display panel displays the Controller Unit BATTERY status. If the Controller
Unit battery is low, the yellow light “BAT” will flash. Otherwise this light will be on
steady.
2.5.5. Remote Unit Battery Status: The yellow select light at each of the “1”
through “4” or “8” switches will indicate the selected Remote Units’ battery status after
a status request command is issued. If the selected Remote Unit transmitter is within
range of the Controller and Remote Unit's battery is low, the yellow select light for that
Remote Unit will flash. Else, the select light will be on steady.