User's Manual

1673 OPERATION MANUAL REV A
46
6.3.5. Each event is provided a time and date stamp, and GPS coordinates are included if the
GPS module is installed and a GPS signal is available. Figure 6-2 shows provides an example of
the history log from a Controller unit with date, time, and GPS coordinates for each event.
Figure 6-2 Event History Log for Controller
6.3.6. In the ‘System’ column of the Controller’s event history event log, ‘FV’ is displayed after
firing to indicate the firing voltage for each particular Remote Unit that was fired. For the Electric
Detonator, FV is typically 350-400V. For the Shock Tube Initiator circuit, FV is typically 2,250-
2,750V.
6.3.7. In the ‘Units Selected’, the post fire Motion Detect levels are shown for each Remote that
was fired next to ‘MD’. The Motion Detect level increases with an increasing post-fire vibration level
and has a range from 0 to 254. The threshold level, which is the level that the Controller’s LCD
reports that a motion was detected, is adjustable within the Controller within the Service Menu. The
default setting is ‘50’.