User's Manual

1673 OPERATION MANUAL REV A

5.6. SERVICE MENU

5.6.1. Service Menu a PIN protected menu only available to the manufacturer or authorized

service shops. Service Menu allows changes of various to critical operation parameters such radio

settings, calibration, and arm time. Consult the manufacturer or distributor if you feel you need to

have adjustments to your system.

5.7. FACTORY MENU

5.7.1. Factory Menu is a PIN protected mode where change can only be performed by the

manufacturer.

5.8. PROGRAMMING ELECTRONIC KEYS

5.8.1. The Key Programming Mode of the Controller allows you to create replacement keys if

you have a lost or damaged key, or you can create a new key if you need to add a new Remote to

your system. An important feature of the key programming mode is that it will not allow duplicate

keys to be created. This means that if a key is lost or stolen, once you reprogram the keys, the key

that was lost or stolen will no longer be functional, unless it also is reprogrammed.

5.8.2. When programming a key associated with a particular system, you must also reprogram

all of the other keys associated with that system at the same time (up to 8 Remotes and the

Controller key must be programmed together). You do not need to reprogram keys that are

associated with other systems, unless you are adding or replacing their keys as well.

5.8.2.1. Identify which systems (1-8) the new or replacement keys will be matched to. If you have

8 Remotes or less, by default you will be reprogramming only the System #1 keys. If you have

more than 8 Remotes, you may be programming keys from other Systems as well.

5.8.2.2. Gather all of the keys associated with the system(s) for which you have identified in

5.8.2.1 to the Controller Unit. You must reprogram all Remote Units from that system together at

the same time; even the ones that are working correctly.

5.8.2.3. Remove the Controller’s key from the electronic key port. Turn the Controller on, and

press the MENU switch to enter the start menu.

5.8.2.4. Press ‘2’ to select the Advanced Menu. Enter the PIN supplied to you by the

manufacturer or distributor.