RSS-900 SPEAKER SELECTOR SÉLECTEUR D’ENCEINTES ACOUSTIQUES SPEAKER SELECTOR SELETTORE PER DIFFUSORI SELECTOR DE CAJAS ACUSTICAS LUIDSPREKERSCHAKELEENHEID SPEAKER SELECTOR RSS-900 1 DIRECT 2 3 4 5 ON OFF Owner’s Manual Manuel d’utilisation Bedienungsanleitung Manuale di Istruzioni Manual de Instrucciones Gebruiksaanwijzing
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. APPLICABLE FOR USA, CANADA OR WHERE APPROVED FOR THE USAGE WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electrical shock, do not expose the unit to moisture or water.
SPEAKER SELECTOR RSS-900 Figure 1: Controls and Connections Bedienelemente und Anschlüsse Commandes et branchements Controlli e Collegamenti Controles y Conexiones De bedieningsorganen en aansluitingen SPEAKER SELECTOR RSS-900 DIRECT 2 1 3 4 5 ON OFF 1 5 4 2 3 2 1 DIRECT LEFT LEFT SPEAKER SELECTOR MODEL NO. RSS-900 ROTEL ELECTRONICS CO. LTD.
SPEAKER SELECTOR RSS-900 Figure 2: Typical Connections Exemple-type de branchements Typisches Anschlußdiagramm Collegamenti Tipici Ejemplo Tipico de Conexión De verbindingen ROTEL RB-971 WARNING:TO REDUCE THE RISK OF FIRE POWER AMPLIFIER MODEL NO. RB-971 POWER CONSUMPTION: 250W SPEAKER IMPEDANCE OR ELECTRICAL SHOCK, DO NOT EXPOSE STEREO 4 OHMS MINIMUM THIS EQUIPMENT TO RAIN OR MOISTURE.
English ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Contents (circled numbers refer to illustration) Getting Started About Rotel __________________________________________ Getting Started ______________________________________ A Few Precautions Associated Components Placement Cables Connection __________________________________________ Polarity/Phasing and Proper Channel Connection Input From Amplifier 3 Direct Speak
SPEAKER SELECTOR RSS-900 Associated Components The RSS-900 is designed for use with amplifiers that can produce as much as 200 watts per channel. (See the information in the following section regarding ventilation.) The amplifier should be capable of handling 4 ohm impedance loads. NOTE: If speakers that have a minimum impedance of less than 4 ohms are connected to the RSS-900 the impedance the amplifiers receives may be less than 4 ohms.
English ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Speaker On/Off Switches Troubleshooting [See Figure 1 for switch identification.] Direct Speaker Switch 1 This switch turn on and off the speakers connected to the Direct outputs. Push in the top of the rocker switch to turn the speaker on. Push in the bottom of the rocker switch to turn the speaker off.
RSS-900 SPEAKER SELECTOR SÉLECTEUR D’ENCEINTES ACOUSTIQUES SPEAKER SELECTOR SELETTORE PER DIFFUSORI SELECTOR DE CAJAS ACUSTICAS LUIDSPREKERSCHAKELEENHEID The Rotel Co. Ltd.
