User manual

Operating the HLX-40
HomeLogiX, HLX-40 User Guide
Page 8
2.3.4. Quick Arming
Quick arming allows arming the system without code entry. If
Quick Arming is enabled (by the installer during setup), a long
press on one of the arming buttons activates Quick Arming.
2.3.5. Instant Arming
If Instant Arming mode is enabled (by the installer, during
configuration), the system will skip the exit delay as well as
cancel the entry delay configured, and will initiate the Alarm
instantly causing an alarm to go off upon violation of any zone.
To instantly arm the system:
1. Verify that the system is ready for arming.
2. Press either the Home or the Away
3. Enter your user code.
arming key.
4. Press the same arming key once again.
2.3.6. Forced Arming
If Forced Arming is enabled, the system is able to arm even
when zones are in violation (open) but not defined as
bypassed. In such a case, the system will arm, effectively
bypassing the open zone. Once the open zone is closed the
system will complete arming, adding the previously bypassed
zone to the monitored zones.
2.4 Entry/Exit Delay Options
Entry and Exit actions delay the alarm mode and allow the
system to ignore zone violations, as described below.
2.4.1. Entry Delay
Entry delay allows the user a grace period for the time it takes
him to open the door and reach the keypad. It is the time
allowed to the user to reach the keypad to disarm the system.