User manual

User Menu Options
HomeLogiX, HLX-40 User Guide
Page 29
4. Using the Menu button choose to either Bypass or Un-
Bypass the selected zone, press Enter
5. Arm the system using one of the arming options.
to save your
selection.
6. To arm the system again using the same bypass settings,
press 6
9.7 Enrolling Remote controls
followed by one of the arming buttons.
You can enroll up to eight remote controls, and specify
functions for each button on the remote control. You can also
delete enrolled remote controls.
To enroll a remote control and specify a function:
1. Using the Menu button, select remote Controls and press
Enter
2. Select the desired remote control number 01-08 by either
browsing the remotes using the
.
Menu
3. Enroll the remote control when the
button or by entering
the remote number using the numeric keypad.
WAITING FOR SIGNAL
4. When the signal is detected you will be asked to press the
message is displayed, by pressing a button on the remote
you wish to enroll.
Enter
5. Once the selection is stored, you can then choose to
configure each of the remote control buttons to behave in
one of the following options:
button to store and save your selection.
o Restore Default (reset to its original functionality)
o Operate PGM 1
o Operate PGM 2
o Status Request
6. At any time press the ESC
button to exit the menu.
Note:
Once you exit the menu (after saving the enrollment)
you cannot change the button’s behavior, unless you
delete the remote and re-enroll it.
To delete a remote control
1. Using the Menu button, select remote Controls and press
Enter.