User manual

VIP Menu
HomeLogiX, HLX-40 User Guide
Page 21
6. VIP Menu
6.1 General
VIP (Voice Interface Programming) features include Voice
Assist, where the panel uses voice to prompt the user. Either the
system or a remote private telephone can initiate a VIP session.
• VIP Session Initiated by a Remote Telephone User: The
remote telephone user can initiate a VIP session by calling
the system’s number. The system answers after a preset
number of rings, press *
• VIP Session Initiated by the System: The system initiates a
session (if enabled by the installer) upon an event
occurrence. The system calls the private number and asks
that you press
to initiate connection the system
broadcasts the site description and waits for a code. The
remote user must enter a valid master code to start a
session.
*
The system switches to voice menu mode when a valid master
code is entered. During voice menu mode, the system uses
voice messages for menu options. Follow the voice instructions.
to initiate the connection after which the
system broadcasts the site and the event description. The
user must then enter a valid master code to enter the VIP
menu. The system hangs up after approximately 60
seconds of no activity. In the event that there is no answer
from a private phone or disconnected by the user by
pressing 9, the system switches to the next private number.
The system retries calling the programmed private phones
for a preprogrammed number of attempts unless the user
disconnects the call session by pressing 9 in which case the
session is stopped completely.
Press 0
The following options are available:
at any time to jump one level up in the menus.
• Press 1
• Press
to enter the arming options submenu
2
• Press
to enter the automation options submenu
3
• Press
to enter the voice operation options submenu
4
• Press
to receive a status report
9
to exit the menu and disconnect the system.