Specifications

Installer Menu

54 HLX-40 Installer Manual

6.9.2 RF Test

RF testing checks the signal strength of all the wireless devices enrolled to the

system. If a weak signal is detected, a repeater may be used to improve the

link quality.

The system saves the most recent set of RF test results for uploading. The

system clears the tests when running another RF test.

To perform the test:

1. Using the Menu button select the test you wish to perform, and press the

Enter button to access the test.

2. Activate the RF unit to send a signal to the unit. The results can be

Strong

Normal

Low

. The available tests are:

 Test Detectors

 Test R. Controls

 Test R. Siren

 Test Keypads

 Test Repeaters

To view the results:

1. For each of the tests, you can review the results by pressing the Enter

button and then either the Menu button or the alphanumeric keys review

all the units.

2. To exit the RF test mode you must press the ESC button.

6.9.3 Test Indicators

The indicators test checks the two indicator LEDs, power and status, located on

the Panel.

To test the indicators:

After entering this menu, press Enter. The LEDs blink three times.

6.9.4 Sirens test

This test checks the different available sirens by activating them.

To test the sirens:

1. Select the siren you wish to test:

 Local Siren

 External siren

 RF siren

 Siren 1

 Siren 2

 Siren 3

 Siren 4

2. Press Enter to activate the sounder.

3. Press ESC to stop the siren.