Specifications

Installer Menu
HLX-40 Installer Manual 47
For PABX use the digit followed by "*" and then the full number.
d. Account Code – The number that identifies your system to the
central station. The account code range is 0–9, B, C, D, E, and F.
i. Using the alphanumeric keypad, enter a code of four
digits/letters
ii. Press Enter to confirm
e. Report Options – Specify the event groups that are included in a
report.
i. Using the Menu button, choose the reporting options for each
group as desired, the options are Disable, and Enable. Press
Enter to confirm, the available reporting groups are:
 Alarms
 Troubles
 Alerts
 Bypass
 Arm/disarm
 Restore
ii. Press ESC to exit the submenu.
f. Ack Timeout – Specify the time that the system has to send a report
event before the report alert is discontinued.
i. Using the alphanumeric keypad, set the value of the Ack timeout
to a value of 10 to 60. Press Enter to confirm.
g. Signal Gain – Specify the strength of the DTMF.
i. Using the alphanumeric keypad, set the value of the signal gain
to a value of between 100 to 9999. Press Enter to confirm.
h. CS Secondary – Specify the secondary Central Station (see CS
Primary above for detailed options and instructions).
i. CS Protocol – Specify the reporting protocol used by the system to
report events to the central stations. Currently only Contact ID is
available.
j. Dialing Attempts – Specify the number of times the system
attempts to dial the primary stations number before attempting to
dial the secondary number. The default is 3 attempts.
i. Using the numeric keypad, enter the dialing attempts value
between 1 and 15.
ii. Press Enter to save.
k. Link Setup – Specify the communication type used for each of the
two central stations (CS primary and CS secondary).