User manual

SMS Commands
28 HLX-40 User Manual
8. SMS Commands
The HLX-40 family supports remotely controlling the system using a cellular
phone by accepting SMS commands from the user’s cell phone to the GSM’s
SIM card provided that the MD-CC101 GSM Stick expansion is installed and
functioning properly.
To perform cellular remote commands:
1. Send an SMS command according to Table 8 along with either the Master
code or one of 20 enabled user codes.
The format of the message is the command as listed below, space,
followed by the master or user code.
For example: “Arm Away 1234”
Table 8: SMS Commands
Message To
Arm Away
Arm the system in Away mode. This mode arms all
sensors and detectors. Use this function when there is
no one in the home/office.
Arm Home
Arm the system in Home mode. This mode arms all
perimeter sensors and detectors as defined by the
installer. Use this function when the home/office is
occupied.
Disarm
Disarm all armed sensors and detectors.
If the duress code is enabled by the Installer, entering
the duress code when disarming sends a duress event to
the Central Station and to a private phone.
Activate PGM1
Activate a predefined PGM designated by the installer
PGM1
Deactivate PGM1
Deactivate a predefined PGM designated by the installer
PGM1
Activate PGM2
Activate a predefined PGM designated by the installer
PGM2
Deactivate PGM2
Deactivate a predefined PGM designated by the installer
PGM2