User manual

Operating the HLX-40
HLX-40 User Manual 11
2.3.2 Arm Home
Home arming is an arming of all perimeter sensors and detectors as defined by
the installer. This is intended for when home or office is occupied.
To arm the system using HOME:
1. Verify that the system is ready for arming.
2. Press the HOME arming key.
3. Enter your user code.
2.3.3 Disarmed
When disarmed, the HLX-40 system enters Alarm mode for each 24-hour
zone. Alarms trigger only for panic, emergency, fire, 24-hour audible, and
silent conditions.
In this state, the system continuously checks zone status and holds the Ready
status parameter. This parameter determines whether the system is ready to
arm. The system becomes Ready to Arm when zones are either closed or
bypassed, or Force Arming is enabled.
To disarm the system:
1. Press the Disarm key.
2. Enter your user code.
2.3.4 Quick Arming
Quick arming allows arming the system without code entry. If Quick Arming is
enabled (by the Installer during setup), a long press on one of the arming
buttons activates Quick Arming.
2.3.5 Instant Arming
If Instant Arming mode is enabled (by the Installer during configuration), the
system skips the exit delay, cancels the entry delay configured, and initiates the
alarm, which instantly causes an alarm to go off upon violation of any zone.
When EN-CENELEC standard is enabled, only the Master user can use this
feature.
To instantly arm the system:
1. Verify that the system is ready for arming.
2. Press either the HOME or the AWAY arming key.
3. Enter your user code.
4. Press the same arming key once again. (If EN-CENELEC standard is
enabled, enter your Master user code once again).