Programming Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 Entering the Programming Mode
- 4.2 Exiting the Programming Mode
- 4.3 Changing the Open Code
- 4.4 Changing the Auxiliary Code
- 4.5 Changing the Programming Code
- 4.6 Changing the Normal/Secure Code
- 4.7 Changing the Normal/Bypass Code
- 4.8 Setting Fail Safe/Secure Operation, Tamper Siren and Lock Strike Release Time
- 4.9 Setting Auxiliary Modes
- 4.10 Keypad Heater Operation
- 4.11 Setting the Lockout Feature
- 4.12 Setting the Backlight Behavior
- 4.13 Enrolling Primary and Secondary Codes
- 4.14 Deleting Primary and Secondary Codes
- 4.15 Relay Codes Assignment
- 4.16 Changing PIN Code Length/Factory Default Settings
- 4.17 Replacing a Programming Code
- 4.18 Replacing a Normal/Secure Code
- 5. Technical Specifications
Introduction
AC-Q4x Series Installation and Programming Manual 9
1. Introduction
The AC-Q4x series are vandal resistant standalone controllers. All
the units are water resistant and suitable for indoor or outdoor
mounting. The unit(s) accepts up to 500 users and allows entry via
a personal identification number (PIN) and/or by presenting a
proximity card.
1.1 Controller Types
The different types of control units described in this manual are:
Type 41 – PIN only
Type 42 – PIN and proximity card
Type 44 – PIN and proximity card, with piezoelectric contacts
Heater Relay
Current
Backlight Keypad
Type
Proximity
AC-Q41HB
2 A
Standard
AC-Q41HP
2 A
Standard
AC-Q41SB
2 A
Standard
AC-Q42HB
2 A
Standard
AC-Q42HP
2 A
Standard
AC-Q42SB
2 A
Standard
AC-Q44
2 A
Piezoelectric










